Learn how to get extreme steering angle for your drift car! Not only will you learn how to install an angle kit, but you will learn how to replace the entire front suspension including the lower control arm, wheel bearing, tie rods, coilovers, sway bar, steering knuckle, and brakes.
Tools and Products
Bump Steer Kit: http://amzn.to/2DvleBE
Angle Kit: https://goo.gl/5ZiZQK
Extendable Ratchet: http://amzn.to/2DzNH9x
Wrench Set: http://amzn.to/2Dty2cA
Torque Wrench (goes to 250ft-lbs):http://amzn.to/2DV6WrY
Thread locker: http://amzn.to/2BfMCi2
Antiseize: http://amzn.to/2roe8Kz
Electric Cutoff Wheel: http://amzn.to/2DlXvk8
Wheel Bearing: http://amzn.to/2DztiRM
Stiffer Springs: http://amzn.to/2Dm936Q
Thanks Chris Forsberg for footage of his car: https://www.youtube.com/user/chrisforsbergracing
→ Become a ChrisFix Subscriber: http://www.youtube.com/subscription_center?add_user=paintballoo7
→ Instagram: https://www.instagram.com/chrisfixit
→ Facebook: https://www.facebook.com/chrisfix8
→ Website: http://www.ChrisFixed.com
→ My Channel Home Page: https://www.youtube.com/ChrisFix
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Week**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.

15 thoughts on “How to install an angle kit shopping cart angle”
  1. Avataaar/Circle Created with python_avatars Rilabug says:

    medium-strength threadlocker.

  2. Avataaar/Circle Created with python_avatars Yakel says:

    How to: Lightning mcqueen in cars 1

  3. Avataaar/Circle Created with python_avatars Cats says:

    He has no medical conditions. But he has a lover medium strength thread-Locker. This is Chris

  4. Avataaar/Circle Created with python_avatars Vypher says:

    The addition of no front sway bar allows you to run a stiffer performance orientated sway bar in the rear and adjust your camber in your rear to be slightly greater than the front to allow the front, Allowing the vehicle to lean into the corners in the event you must drive evasively in a dangerous road environment. Which improves traction

  5. Avataaar/Circle Created with python_avatars lens of glory says:

    Please add some nos

  6. Avataaar/Circle Created with python_avatars gabriele aloisio says:

    Chrisfix could you make a video about how to install a turbo or supercharger because all the other youtubers are not explaining it good and you can explain it good (i really like your video's)

  7. Avataaar/Circle Created with python_avatars Euno says:

    Wow it’s been 5 years since this video came out.
    This was my first video that I watched and still watching the videos 5 years later.

  8. Avataaar/Circle Created with python_avatars leon craig says:

    Wow really good im so proud

  9. Avataaar/Circle Created with python_avatars Power Gamer says:

    so imagine that i dont have a car for drift is it worth it to use an angle kit anyways ?

  10. Avataaar/Circle Created with python_avatars Beth Mills says:

    Do you turn a Nissan GT-R into a drift car

  11. Avataaar/Circle Created with python_avatars kasaps says:

    its 2am, i have 2 assignments due today and i dont own a car

  12. Avataaar/Circle Created with python_avatars tuvshuu says:

    I don't think that's bad design because it maybe holds the bolt in there

  13. Avataaar/Circle Created with python_avatars Skittles videos says:

    Hey guys Chris fix is here😂❤

  14. Avataaar/Circle Created with python_avatars Riley Carter says:

    I just screwed shopping cart wheels to a metal pipe I welded on

  15. Avataaar/Circle Created with python_avatars jack_leinen says:

    3.5 inches? Dude that’s totally average

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.