Paint your brake calipers to keep them looking good and rust free. This video will give you the outline of what you would need to do to paint your own brake calipers. I go over the tools and supplies you will need, the different steps it will take to get a good finish and you can see what the results look like.
Here is the spray paint I used (It comes in other colors too): http://www.amazon.com/gp/product/B003CT4AKC/ref=as_li_tl?ie=UTF8&camp=1789&creative=390957&creativeASIN=B003CT4AKC&linkCode=as2&tag=chri0e2-20&linkId=PEV46MBCYCBOJ4CK
Paint Your Brake Drums:
https://www.youtube.com/watch?v=djmDciOIuls
How to change Front and Rear Brake Pads and Rotors: https://www.youtube.com/watch?v=lU6OKQxSg8U
How to bleed/flush your Brakes: https://www.youtube.com/watch?v=n1NvtUwfRJc
Paint Your Brakes: https://www.youtube.com/watch?v=djmDciOIuls
Drum Brake Replacement: https://www.youtube.com/watch?v=zJ_UXP6GWkwWheel Cylinder Replacement: https://www.youtube.com/watch?v=GIWYkCOPAQ0Chrysler
How to Replace a Brake Caliper: https://www.youtube.com/watch?v=nbdJGCi29nQ
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Thursday**
-Website: https://www.ChrisFixed.com
-Facebook: https://www.facebook.com/chrisfix8
-Twitter: https://twitter.com/ChrisFixed
-Instagram: https://instagram.com/chrisfixit
-Subscribe Here: http://www.youtube.com/subscription_center?add_user=paintballoo7
-YouTube Channel: https://www.youtube.com/ChrisFix
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.

16 thoughts on “How to paint brake calipers fast and easy”
  1. Avataaar/Circle Created with python_avatars Marlon Fb6_raiden says:

    Hey @chrisfix
    Is it necessary to primer it if i will be using red?!

  2. Avataaar/Circle Created with python_avatars William van Gils says:

    Just dip the caliper in Cetric acid/water bath and warm the solution with a aquarium heater to 100 degrees. The results will be far superior and less sanding.

  3. Avataaar/Circle Created with python_avatars Elijah Pena says:

    Really helpful dude

  4. Avataaar/Circle Created with python_avatars John Brady says:

    Sooooo. Just prep it for cosmetics?? I’m genuinely curious. I’m new to working on cars and don’t wanna misunderstand. Thank you!!

  5. Avataaar/Circle Created with python_avatars Mark Dibuono says:

    Why did you not try to mask the pistons. Do you just stay away from it and know since it’s thin that it will eventually flake off?

  6. Avataaar/Circle Created with python_avatars Tib says:

    Brake caliper covers, go on in few min

  7. Avataaar/Circle Created with python_avatars sergio fimbres says:

    Can you get anoying noices from painting your calipers without removing break pads?

  8. Avataaar/Circle Created with python_avatars Raquel Barron says:

    Chris your the Shit!
    Love your videos!
    Thank you for being thorough and awesome!

  9. Avataaar/Circle Created with python_avatars 122Music1 says:

    FYI, Vinegar would be good after rust removal to stop most future oxidation/rust.

  10. Avataaar/Circle Created with python_avatars Simon 1998 says:

    hey, nice video. I do however advise a smaller metal wire brush, yours is still quite big xD

  11. Avataaar/Circle Created with python_avatars Vlad Olshanski says:

    Зачем 2раза обезжиривать?Нужно было после демонтажа зашкурить а потом уже один раз!!!обезжирить

  12. Avataaar/Circle Created with python_avatars Shorty Larson says:

    i finally saw what he looks like! reflection in the goggles

  13. Avataaar/Circle Created with python_avatars Alberto Ruiz says:

    I did this for my project car 84 corvette and it looked so nice

  14. Avataaar/Circle Created with python_avatars Axxetto says:

    5 bucks, nowadays, I had to buy 1 can for 22$

  15. Avataaar/Circle Created with python_avatars Kneel says:

    This shit takes forever…way easier watching somebody do it in a video .

  16. Avataaar/Circle Created with python_avatars Rubdul Bah says:

    Red paint is the PC RGB lights of automotive work.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.